ASTRO VG-876, Instruction Manual

Page: 88 / 543

74
(10)
Sub Sampling (0/1)
In case of « Side by Side » and « Top & Bottom », set it either normal drawing
or thin-out drawing.
0 OFF
Normal drawing
1 ON Thin-out drawing
(11) Left/Right Color If you set « Use » in L, R Color , set pattern color and back color in each left
and right picture.
Coor(L) (R )
R,G,B
Set pattern color of each Left and Right picture.
Setting range : 0-65535 (max value will change by
BitMode.)
Back color L) (R )
R,G,B
Set back color.
Setting range : 0-65535 (max value will change by
BitMode.)
(12) V.Bar Width (1-16)
If you set « Vertical Bar » in Type , the width of vertical bar can be set.
Setting range : 1-16 LANE
(13)
Slant Angle (0-B)
If you set « Slant Color Bar » or « Slant Gray Bar » in Type, set drawing
angle here.
0 0 degree
1 15 degrees
2 30 degrees
3 45 degrees
A 150 degrees
B 165 degrees
(14)
Checker
A checkerboard pattern is set when Checker DOT or Checker BLOCK has
been specified as
the Type setting .
This is the same setting as the regular checkerboard pattern. (Refer to
section “4.8 Checkerboard patterns.”)
(15) Window / Circle Set a parameter of Window / Circle that is selected in Type.
Type (0-3) Select kinds of pattern
0 Window Draw one Window.
1 Circle Draw one Circle.
2 9 Window Draw 9 Windows.
3 9 Circle Draw 9 Circles.
Real Circle (0/1)
In Type, if you select Circle or 9 Circle, select if the circle
should be true-circle or not.
0 OFF Draw circle based on H and V size.
1 ON Draw true-circle.
Size
H, V
Set the drawing size of the pattern.
Setting range : 0-100 [%]
LPosition
RPosition Set the drawing position of Window / Circle in each Left
and Right picture. The setting value becomes the center
of the pattern.
Setting range : 0-100 [%]
Position Set the drawing position of 9 Windows / 9 Circles .
The setting value is regarded as the blank area from the
edge of screen.
Setting range : 0-100 [%]
(16) Cross Hatch If you select Cross Hatch in Type , set the details of Cross Hatch.
This is the same setting as the regular Cross Hatch pattern. (Refer to section
“4.10.3 Cross Hatch.”)