ashtech DG14, Reference Manual

Page: 340 / 390

320 DG14 and DG16 Board & Sensor Reference Manual
DIR,DEL: Delete Beacon Station from Beacon Directory
$PASHS,BCN,DIR,DEL,f1,[d1]
This command deletes the specified Beacon station from the Beacon directory
where f1 is the frequency, in KHz, and d1 is the Station ID.
If you do not specify a Station ID, then all stations with the frequency specified are
deleted from the Beacon directory.
If you specify both a frequency and Station ID, the frequency must match the
frequency for the specified Station ID, or no Beacon station will be deleted from the
Beacon directory.
If you specify a Station that is locked, then deleting the Station from the Beacon
directory will not remove the Never-Use lock from the station. You must use the
$PASHS,BCN,CLR to remove the Never-Use lock.
DIR,INI: Reset Beacon Directory
$PASHS,BCN,DIR,INI
This command restores the Beacon directory from FLASH to the factory defaults.
MAN: Manual Mode
$PASHS,BCN,MOD,MAN
This command sets the DG16 Beacon functionality to Manual mode. For more
information on the Beacon Manual mode, see
Manual Modes , on page 71.
After manual mode is set, both Beacon channels stop operating until the channels
are assigned specific stations/frequencies with the
$PASHS,BCN,CHN command
(For more information on the $PASHS,BCN,CHN command, see page CHN:
Assign Beacon Station Channel , on page 317).
MOD: Query Beacon Mode
$PASHQ,BCN,MOD
This command queries the mode that the Beacon functionality is currently in.
$PASHR,BCN,MOD
The response is in the format:
$PASHR,BCN,MOD,s1,s2