ashtech DG14, Reference Manual

Page: 320 / 390

300 DG14 and DG16 Board & Sensor Reference Manual
STH: Differential Base Station Health
$PASHS,RTC,STH,d1
This command sets the health of the base station, where d1 is a code number
between 0 and 7. The health states and the corresponding codes are listed in Table
9.6. This command applies to base station mode only. You can view the current
base station health setting by entering the
$PASHQ,RTC command and checking
the STH field.
Example
Enter the following command to set the base station health code to indicate that
the base station is not working:
$PASHS,RTC,STH,7
STI: Differential Base/Remote Station ID
$PASHS,RTC,STI,d1
This command sets differential station identification numbers, where d1 is any
number between 0000 and 1023. A remote station with the ID number 0000 can
receive corrections from any RTCM base station; otherwise, the remote station
must be programmed with the same ID number as the base station in order to
receive corrections from that base station.
Table 9.6. $PASHS,RTC Health of Reference
Code Base Station Health Status
7 Reference station not working
6 Reference station transmission not monitored
5 Specified by service provider
4 Specified by service provider
3 Specified by service provider
2 Specified by service provider
1 Specified by service provider
0 Specified by service provider
DEFAULT SETTING
RTC,STH— 0