ashtech DG14, Reference Manual

Page: 295 / 390

NMEA Commands 275
NMEA Commands
Table 8.47 outlines the response message.
TCM: Differential Remote Station Status
$PASHS,NME,TCM,x,c,[f]
This command enables or disables the RTCM rover data message, where x is the
port, A or B, c is ON or OFF, and f is the optional message output rate ranging from
0.05 to 999 seconds depending on the measurement update rate option installed.
If the command is set without a period, the DG16 uses the period set by the
$PASHS,NME,PER command If the $PASHS,NME,PER command is issued after
this message period has been set, the period resets to the PER setting.
Table 8.47. Typical SAT Message
Field Description
$PASHR,SAT Header
03 Number of satellites locked
03 PRN number of the first satellite
103 Azimuth of the first satellite in degrees
56 Elevation of the first satellite in degrees
60 Signal strength of the first satellite
U Satellite used in position computation
23 PRN number of the second satellite
225 Azimuth of the second satellite in degrees
61 Elevation of the second satellite in degrees
39 Signal strength of the second satellite
U Satellite used in position computation
16 PRN number of the third satellite
045 Azimuth of the third satellite in degrees
02 Elevation of the third satellite in degrees
21 Signal strength of the third satellite
U Satellite used in position computation
6E Checksum