CS175-275-575-875 Installation Guide
153
Automatic arming
If programmed, the CSx75 auto arms at a specified time. At this time, the
keypad beeps for 50 seconds before the panel arms. The arming process is
stopped if a code is entered on the keypad. The CSx75 then attempts to arm
after every 45 minutes of inactivity until the next opening time (location 52), or
until the system is armed. The 45-minute timer is extended when there is
activity in the building causing the Ready LED to turn off and on. If closing
reports are sent, the user code is 97.
See
Location 34
on page 65 and
Location 52
to
Location 55
, starting on page
71, for more information.
Automatic bypass
If enabled, the control panel can automatically bypass interior follower zones if
an exit is not detected during the exit delay time. Entry delay zones can also
be made instant.
See
Location 34
on page 65 for more information.
Auxiliary outputs
The CSx75 has four programmable outputs that can be used to activate
relays, LEDs, etc.
See
Location 57
to
Location 62
, starting on page 73, for more information.
Auxiliary power
overcurrent
This indicates that too much current is drawn from any device powered by the
system. This condition can be reported to the central station.
See
Location 51
on page 70 for more information.
Binary coded decimal
A method of calculating and displaying numbers.
Box tamper
The CSx75 has an input for a normally closed tamper switch. The box tamper
can be programmed to report and/or sound the siren and/or the keypad.
These terminals can be enabled or disabled in programming.
See
Location 49
to
Location 51
, starting on page 69, for more information.
Built-in siren driver
The CSx75 has a built-in 112db siren driver. When desired, this built-in driver
can be easily converted to a 1-amp voltage output through programming. The
siren can be 15 or 30 Watt maximum, with an impedance of 4, 8 or 16 ohms.
See
Location 50
on page 69 for more information.
Burglary zone type
This is armed when the system is armed. A forced arm can exclude it.
Buzzer
A local low volume vibrating audio output located in the keypad.
Bypass toggle
This feature lets the end user turn on and off the bypass of an interior zone
with the system armed by pressing the Bypass key.
See
Location 34
on page 65 for more information.
Bypassed zones
Zones that are left open when the rest of the system is armed. They can be
entered without triggering an alarm.
Call back
If enabled, the control uses the call back phone number to call the download
computer before beginning a download.
See
Location 32
on page 64 for more information.
