104
CS175-275-575-875 Installation Guide
Transmitter
Action
Door/Window
Activate tamper switch by removing the cover.
Door/Window with
external contact
Activate tamper switch by removing the cover.
PIR
Activate tamper switch by removing back plate from PIR.
Smoke detector
Press and hold the test button.
Single Button Panic
Press and hold the button.
Dual Button Panic
Press and hold the buttons together.
Keyfobs
Press and hold the arm and disarm buttons together.
17.4.4 Deleting transmitters
The following steps describe how to delete transmitters from the module.
The module ignores a transmitter but does not remove the transmitter identification from
its memory. The transmitter can be reactivated later or a new one can be learned into the
zone.
Steps
1. Press
8
to enter programming mode.
2. Enter
a
Go to Program Code
. The keypad prompts you to enter a module
number.
3. Enter the module number and press
#
. (This is the DIP switch setting and can
have a value between 32 to 39.
4. Press XX# where XX is the zone number (1 to 168) and where # is the entry key.
5. Press 1 to change the transmitter feature 1 (Transmitter Enabled). The first bit in
the segment changes from ‘
1’
to ‘
-‘
, to indicate that the wireless component is
disabled.
6. Repeat steps 4 to 5 until all transmitters are deleted.
7. Press
the
Exit
key twice to exit programming mode.
17.4.5 Testing wireless transmitters
During the installation and/ commissioning of the system, it is mandatory to check the
signal strength of all transmitters and record the signal strength in the system
documentation.
Part of the commissioning procedure of an 868 MHz wireless system is to record the RSSI
readings from each device.
Steps
1. Press
8
to enter programming mode.