IPX-100 system installation & configuration
Page-12
TELECOMMUNICATIONS
3
System installation requirments
1.
The system must be placed in a dry, dust-free place, 10 cm above the ground to avoid vibration
。
2.
Choose a well-ventilated place and avoid direct sunlight to avoid excessive system temperature.
3.
Main system cabinet installation location Select the center location of the extension phones to
have shortest the distance between the main system and the extension phones. The system
should take an indipent power supply, preferably directly from the main power switch. Do not
share with other loads, especially those that consume large amounts of power, and away from
high frequency and noisy environments to avoid radiated (EMI) noise interference.
4.
The power socket required three-hole power socket (with a ground pin socket).
5.
Measure the power voltage with an electric meter. If the power voltage is unstable, please install
a voltage regulator.
6.
The lightning protection ground must be properly installed and well connected.
7.
The wiring cord of the external line and the extension phone must be a pair of twisted wires to
avoid noise interference.
8.
Do not wire the extension wire along or close with the high-power cord or other sources of
interference (eg radio...). Otherwise please use an isolation wire and be sure well-connected to
the ground wire connection for the isolation.
9.
The structural constraints of the enclosure, for safety reasons, when the system is mounted on a
Rack, a rack tray is requested to be equipped to avoid deformation of the enclosure.
4
Preparation of system installation
1.
Check the system capacity and number of phones.
2.
Check installation tools, wires, etc.
3.
Please follow the installation instructions as this manual.
