IPX-100 system installation & configuration
Page-50
TELECOMMUNICATIONS
4-1-1-1
FXO Port
a.
General
The general setting column is used to set the basic operating parameters of this FXO port as
below.
：
Trunk ID
Set the trunk line number to which this FXO port is located. The options are
CO01~CO99, but only all trunk line numbers that are not used by other FXO
port and SIP trunk lines are displayed.
Trunk Name
The system will automatically preset the name when setting it quickly, and you
can change it yourself.
Use Caller ID
Enable caller detection, the options are as below
：
Yes Automatically detect caller message sent by the line end.
No Not detected.
b.
Technology
The technical column sets the hardware operation parameters for this FXO port, which are as
below
：
Active Service
Whether to enable this, the setting options are as below
：
Yes Enabled this port, the system uses this port to dial in or
out.
No Disabled this port.
Port No.
The hardware number of this file (read only).
Ring Detect ON Time
Hardware detection ringing time (ringtone).
Ring Detect OFF Time
Hardware detection ringing time (mute).
Received CallerID Waiting Time
Time to wait for the signal of the caller message sent by the
office line.
Gain settings
Whether to enable the independent amplification gain
setting of port, the options are as below
：
Disable
System-set shared amplification gain setting.
Enable
Use independent amplification gain settings.
Tx Gain
Only applicable to the transmission amplification gain value
of this unit, the gain value option is -4B~+9B.
Rx Gain
Only applicable to the receiving amplification gain value of
this unit, the gain value option is -4B~+9B.
