8-7
8
6. Measure the distance from the inside of each front
rim to the lower frame tube.
AF785D
AF786D
NOTE: The distances from the inside rims to the
frame tubes should be equal. If the measurements
are equal, proceed to step 8; if the measurements
are not equal, proceed to step 7.
7. To make the measurements equal, loosen the
appropriate tie rod jam nuts and adjust accord-
ingly; then proceed to step 8.
AF617D
AF778D
NOTE: The front wheels do not have to be
removed to adjust the tie rod. Also, care should be
taken not to disturb the handlebar position.
8. Using a permanent marker of some type, mark the
center of each front tire (at a height parallel to the
belly panel).
AF789D
9. Measure the distance between the marks (at a
height parallel to the belly panel) at the front side;
then record the measurement.
10. Push the ATV forward until the marks are parallel
to the belly panel on the back side; then measure
the distance between the marks.
11. The difference in the measurements must show
1/8-1/4 in. toe-in (the front measurement 1/8-1/4
in. less than the rear measurement).
12. If the difference in the measurements is not within
specifications, adjust both tie rods equally until
within specifications.
NOTE: Prior to locking the jam nuts, make sure
the ball joints are at the center of their normal
range of motion and at the correct angle.
Next
Back
Section
Table of Contents
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
