9-3
9
INSTALLING
1. Position the brake housing on the handlebar.
Secure with clamp screws; then tighten securely.
DE058A
2. Using two new crush washers, connect the
banjo-fitting to the master cylinder; then secure
with the banjo-fitting bolt. Tighten to 20 ft-lb.
DE059A
3. Gently press the brakelight switch into the housing
(left to right) until the mounting tabs snap into the
four locating holes; then install the brake lever,
pivot pin, and snap ring.
BC206
4. Bleed the brake system (see Section 2).
Throttle Control
REMOVING
1. Remove the two machine screws securing the
throttle control to the handlebar.
2. Slide the grommet out of the lower half of the
throttle control; then remove the cable from the
actuator arm.
AF676D
3. Remove the cap screw, lock washer, and washer
securing the actuator arm to the throttle control
lever.
AF677D
4. Remove the actuator arm and account for a bush-
ing. Note the position of the return spring for
installing purposes.
AF678D
Next
Back
Section
Table of Contents
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
