6-10
CC875
CC876
8. Using the Pinion Gear/Shaft Removal Tool and a
hammer, remove the pinion gear from the gear
case housing.
CC878
9. Secure the pinion gear in a bearing puller; then
remove the pinion bearing using a press. Account
for a collar and a bearing.
CC879
NOTE: If gears are being replaced, use the exist-
ing shims. The numbers are scribed onto the
gears: the ring gear has the number on the oppo-
site side of the gears, and the pinion gear has the
number on the end of the pinion gear shaft by the
splines. If no number is present, it should be con-
sidered as being in the 0 category.
NOTE: If the gear case housing is being replaced,
proceed to the following Shimming Proce-
dure/Shim Selection sub-section.
Shimming Procedure/Shim
Selection
1. Press bearings into bores by outer ring to contact
with seat.
2. Install the lock collar and tighten to 125 ft-lb; then
on final assembling, stake the lock collar edge
approximately 1.5 mm into the lower oil channel.
CC891
3. Note the following shim selections (shims are
nominally 1.5 mm thick):
738-268C
A. Cover Side - add value A on the gear case hous-
ing to value B on the gear case cover; then add
1.5 mm. This will give you the proper shim
thickness.
NOTE: When shimming a rear gear case, add
value A to value B.
Next
Back
Section
Table of Contents
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
