4-3
4
7. Remove the screws securing the throttle actuator
cover to the throttle body; then remove the cover.
FI536A
8. Remove the throttle cable from the actuator arm.
9. Loosen the outer jam nut securing the throttle
cable to the throttle body; then route the cable out
of the way.
10. Remove the three electrical connectors from the
throttle body components.
FI528A
11. Loosen the clamp at the front of the throttle body
and remove the assembly from the intake boot.
FI536B
12. Use tape to cover and seal the intake opening.
NOTE: None of the EFI components housed in
the throttle body are serviceable and must be
replaced if out of tolerance as indicated by trouble-
shooting or malfunction indicator light codes (see
ECU Malfunction Codes in Section 5).
INSTALLING
1. Install the throttle body into the intake boot and
secure with the clamp. Tighten securely.
2. Connect the throttle cable to the throttle body and
adjust throttle free-play (see Section 2).
3. Connect the three electrical connectors to the
throttle body components.
4. Install the air filter housing assembly and connect
and secure the inlet duct boot and crankcase
breather hose; then connect the coil and main har-
ness connector and connect the spark plug cap to
the spark plug.
FI519A
5. Install the air inlet duct connecting the air filter
housing to the throttle body and secure with hose
clamps; then connect the three electrical connec-
tors.
FI516A
CAUTION
Any objects or liquid entering the intake opening will
fall into the engine causing severe damage if the
engine is turned over or started.
Next
Back
Section
Table of Contents
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
