6-14
CC888
2. Using a suitable driver, install the needle bearing
into the gear case housing making sure the bearing
is seated.
NOTE: Do not push the bearing too far into the
housing.
CC889
3. Install the pinion shaft and secure with the existing
48 mm lock collar. Tighten to 125 ft-lb.
CC890
4. Place a punch on the edge of the lock collar in the
oil gallery area; then using a hammer, stake the
lock collar to ensure that the collar will remain
securely tightened.
CC891
5. Install the pinion housing.
Removing/Installing Axle Seal
NOTE: This procedure can be performed on a
rear gear case.
1. Remove the seal using a seal removal tool.
CC899
2. Using a press, remove the bearing.
CC900
3. Using a press, install the new bearing into the
housing.
Next
Back
Section
Table of Contents
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
