6-15
6
CC901
NOTE: Prior to installing the seal, apply High Per-
formance #2 Molybdenum Disulphide Grease to
the seal outside diameter.
4. Using an appropriate seal installation tool, evenly
press the seal into the cover bore until seated.
CF278
5. Repeat steps 1-4 for the opposite side.
INSTALLING DIFFERENTIAL
1. Align the splined input yoke with the front output
splines; then place the differential into position on
the frame and install the cap screws, washers, and
flex-lock nuts. Tighten to 38 ft-lb. Make sure the
rubber boot is properly seated on the input yoke.
CD857
CD859
2. Pour 275 ml (9.3 fl oz) of SAE 80W-90 hypoid
gear lubricant into the differential and install the
fill plug. Tighten to 16 ft-lb.
3. Install the front drive actuator with the three
torx-head cap screws; then connect the wire con-
nector to the main wiring harness.
AG925
4. Install the inner fender panels.
5. Install the front axles (see Drive Axles in this sec-
tion).
6. Secure the upper A-arms with cap screws and lock
nuts. Tighten to 50 ft-lb.
AF610D
7. Secure the lower shock eyelets with cap screws
and lock nuts. Tighten to 50 ft-lb.
CAUTION
Make sure the tool is free of nicks or sharp edges or
the seal will be damaged.
Next
Back
Section
Table of Contents
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
