8-12
6. Place the seat into position making sure it locks
securely.
Taillight Assembly
REMOVING
1. Unplug the three-prong connector and free the tail-
light wiring harness from the frame.
2. Remove the torx-head cap screws securing the
taillight assembly to the frame. Account for any
washers.
3. Remove the taillight assembly.
INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Inspect wiring harness, three-prong connector,
lens, base, cap screws, and socket for damage.
2. Inspect all wires for corroding, pinching, and
cracking.
3. Inspect the bulb for wattage, voltage, and proper
operation.
INSTALLING
1. Place the assembly into position on the frame and
secure with torx-head cap screws and any washers.
2. Tighten the cap screws securely.
3. Route the wiring harness over the rear frame; then
connect the three-prong connector.
Seat
REMOVING/INSTALLING
1. To remove the seat, lift up on the latch release
(located at the rear of the seat). Raise the rear of
the seat and slide it rearward.
2. To lock the seat into position, slide the front of the
seat into the seat retainers and push down firmly
on the rear of seat. The seat should automatically
lock into position.
Next
Back
Section
Table of Contents
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
