6-3
6
4. Loosen but do not remove the mounting cap screw
at the front of the actuator; then slide the actuator
to the rear enough to clear the slotted mounting tab
and the selector shaft.
AG928
INSTALLING
NOTE: Make sure to properly align the differential
lock actuator lever with the hole in the differential
lock plunger.
1. Lubricate the O-rings on the actuator; then ensure
that all mounting surfaces are clean and free of
debris.
2. Align the actuator with the selector shaft and slide
it forward onto the shaft taking care to engage the
cap screw in the slot of the front mounting tab.
AG925
3. While holding the actuator firmly forward, tighten
the front cap screw to hold the actuator in place;
then install but do not tighten the two remaining
cap screws.
AG928
4. Loosen the front cap screw; then tighten the cap
screw on the driveshaft side.
AG926
NOTE: It is important to tighten this cap screw
while the others are loose to ensure proper seating
of the actuator.
5. Tighten the remaining cap screws; then connect
the electrical plug to the main harness.
6. Turn the ignition switch to the ON position and
check the operation by shifting the selector switch
several times.
7. Secure the wiring harness to the frame with a
nylon cable tie; then install the inner fender panel.
Front Differential
NOTE: To remove the rear gear case, see Rear
Gear Case in this section.
REMOVING DIFFERENTIAL
1. Secure the ATV on a support stand to elevate the
wheels.
! WARNING
Make sure the ATV is solidly supported on the support
stand to avoid injury.
Next
Back
Section
Table of Contents
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
