2-7
2
FI530C
3. Remove the drain plug from the bottom of the
engine and drain the oil into a drain pan.
733-441A
4. Remove the oil filter plug from the filter mounting
boss (located on the front side of the transmission
case) and allow the filter to drain completely.
Install the plug and tighten securely.
5. Using the adjustable Oil Filter Wrench and a suit-
able wrench, remove the old oil filter.
NOTE: Clean up any excess oil after removing
the filter.
6. Apply oil to a new filter O-ring and check to make
sure it is positioned correctly; then install the new
oil filter. Tighten securely.
NOTE: Install a new O-ring each time the filter is
replaced.
7. Install the engine drain plug and tighten to 16 ft-lb.
Pour the specified amount of the recommended oil
in the filler hole. Install the oil level stick/filler
plug.
8. Start the engine (while the ATV is outside on level
ground) and allow it to idle for a few minutes.
9. Turn the engine off and wait approximately one
minute.
10. Remove the oil level stick and wipe it with a clean
cloth.
11. Install the oil level stick and thread into the engine
case.
12. Remove the oil level stick; the oil level must be
within the operating range but not exceeding the
upper mark.
GZ461A
13. Inspect the area around the drain plug and oil filter
for leaks.
STRAINER
1. Remove the belly panel.
2. Remove the cap screws securing the oil strainer
cap; then remove the cap.
CC091D
3. Remove the two cap screws securing the strainer;
then remove the strainer.
NOTE: Thoroughly clean any sealant from the oil
strainer cap.
CAUTION
Any oil used in place of the recommended oil could
cause serious engine damage. Do not use oils which
contain graphite or molybdenum additives. These oils
can adversely affect clutch operation. Also, not recom-
mended are racing, vegetable, non-detergent, and cas-
tor-based oils.
CAUTION
Do not over-fill the engine with oil. Always make
sure that the oil level is not above the upper mark.
Next
Back
Section
Table of Contents
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
