MANUAL
© 2004-2009
Aqua Computer GmbH & Co. KG
- 39 -
Gelliehäuser Str. 1, 37130 Gleichen, Germany
15.3. tubemeter
15.3. tubemeter
15.3. tubemeter
15.3. tubemeter
Here you can configure a tubemeter (liquid level sensor, optional acces-
sory, not included in delivery) that is connected via the aquabus to the
aquaero. The following settings are available:
Fill level alarm
Set the fill level in % below which the PC-emergency-shutdown is
activated. (Only works with additional components.)
Should you be using the relay output for other uses, you can enter
the switch value here.
Wave alarm
Adjust the minimum fill level in % of the maximum value below
which the PC-emergency-shutdown is activated. (Only works with
additional components.)
Should you be using the relay output for other uses, you can enter
the switch value here.
Display unit
Here you may choose if the current fill level should be displayed in
% or mm.
LED blinking
Here you can de/activate the blinking of the LED at the tip of the
sensor. This setting only has an optical effect and has no influence
on the measurement.
back:
Leaves the submenu.
15.4. Back
15.4. Back
15.4. Back
15.4. Back
Leaves the submenu and returns to "Settings".
16. Menu „Power Measurement“
16. Menu „Power Measurement“
16. Menu „Power Measurement“
16. Menu „Power Measurement“
This function allows the calculation of the absorbed and emitted power
of up to two cooling circulations. A measurement of the water tempera-
