Aqua Computer AQUAERO 4.00, Owner'S Manual

Page: 10 / 48

AQUAERO
- 10 - Aqua Computer GmbH & Co. KG © 2004-2009
Gelliehäuser Str. 1, 37130 Gleichen, Germany
Pin assignment: Pin 1: GND black wire
Pin 2: GND black wire
Pin 3: D+ green wire
Pin 4: D- white wire
Pin 5: VCC red wire
4.7. LED
4.7. LED 4.7. LED 4.7. LED
Connection possibility for two LEDs or one dual-colored LED (not in-
cluded in delivery) respectively. Standard-LEDs (I max 20 mA) may be
used without a series resistance, which is already integrated in the
aquaero.
Pin assignment:
Pin 1: VCC LED 1
Pin 2: VCC LED 2
Pin 3: GND
4.8. Relay
4.8. Relay 4.8. Relay 4.8. Relay
Floating output. Useable for the emergency shutdown of the PSU (addi-
tional cables required, not included in delivery). Alternatively freely use-
able, maximum breaking capacity 1 A at max. 12 V.
Pin assignment:
Pin 1-2: breaking contact
4.9. aquastream
4.9. aquastream 4.9. aquastream
4.9. aquastream----bridge
bridge bridge
bridge
Connection possibility to the controller of the aquastream. Not co Not co Not co Not com- m- m- m-
patible to aquastream XT pumps, use the “aquabus” header for co patible to aquastream XT pumps, use the “aquabus” header for co patible to aquastream XT pumps, use the “aquabus” header for co patible to aquastream XT pumps, use the “aquabus” header for con- n- n- n-
necting aquastream XT necting aquastream XT necting aquastream XT necting aquastream XT – for details see 4.12. aquabus (I
2
C-bus). A
maximum of two controllers may be connected. Only use cables speci-
fied by aqua-computer (not included in delivery)! The following table
shows the connection possibilities depending on the hardware revision
of the aquastream controller in use:
Revision Controller 1 Revision Controller 1 Revision Controller 1 Revision Controller 1 Revision Controller 2 Revision Controller 2 Revision Controller 2 Revision Controller 2
1.0 or higher Not possible
1.5 or higher 3.0 or higher