MANUAL
© 2004-2009
Aqua Computer GmbH & Co. KG
- 25 -
Gelliehäuser Str. 1, 37130 Gleichen, Germany
10. Menu "Fan Parameters"
10. Menu "Fan Parameters"
10. Menu "Fan Parameters"
10. Menu "Fan Parameters"
Select one of the four fan channels from the list by pressing the "up" and
"down" buttons and confirm your selection by pressing the button
"set/mode".
To leave the menu "Fan Parameters" choose the entry "Back" and con-
firm the selection by pressing the button "set/mode".
Generally, the last used control mode is always used, either control via
temperature sensors, revolution speed or manual control. The entered
values are not lost when the operating mode is switched but are saved
for the next call.
10.1. Fan Name
10.1. Fan Name
10.1. Fan Name
10.1. Fan Name
Enter the name of the fan that should be shown on the display. After the
selection of this menu entry, the current fan name is shown and can be
changed. See also 7.1.1. Definition of Names.
10.2. Sensor 1 (auto)
10.2. Sensor 1 (auto)
10.2. Sensor 1 (auto)
10.2. Sensor 1 (auto)
Activates the control by temperature sensors and assigns the selected
fan one of the temperature sensors one to six or no sensor at all. If two
different sensors are assigned, the sensor that causes a higher fan speed
is used.
10.3. Sensor 2 (auto)
10.3. Sensor 2 (auto)
10.3. Sensor 2 (auto)
10.3. Sensor 2 (auto)
Activates the control by temperature sensors and assigns the selected
fan one of the temperature sensors one to six or no sensor at all. If two
different sensors are assigned, the sensor that causes a higher fan speed
is used.
10.4. Set Rpm
10.4. Set Rpm
10.4. Set Rpm
10.4. Set Rpm
Activates the fan control via revolution speed and allows to define the
fan speed. The fan can either be turned off (0 revolutions) or regulated
in the area from approximately ¼ of the maximum speed to the maxi-
mum speed in steps of 50 rpm/s. The maximum speed for each con-
nected fan is determined automatically when the system is started. If the
