AQUAERO
- 38 -
Aqua Computer GmbH & Co. KG
© 2004-2009
Gelliehäuser Str. 1, 37130 Gleichen, Germany
15. Menu "Periph.
15. Menu "Periph.
15. Menu "Periph.
15. Menu "Periph.----Parameters"
Parameters"
Parameters"
Parameters"
15.1. aquastream 1/2
15.1. aquastream 1/2
15.1. aquastream 1/2
15.1. aquastream 1/2
With application of aquastream-pump(s) with a firmware-revision 1.05
or higher a connection between the aquastream controller(s) and the
aquaero is possible via a separately available cable. This allows the
setup of the functionality of the pump(s). Besides the standard settings,
the deaeration program can be activated and the pump frequency can
be changed between 42 and 74 Hz.
Warning: Please monitor the correct function of the pump after chang-
ing the pump frequency! The use of a flow sensor and an properly acti-
vated flow alarm is recommended.
When simultaneousely connecting two aquastream controllers at least
one of these controllers must be a revision 3 or higher. Two separate
addresses must be activated. Details may be found in the manual for the
aquastream.
15.2. Multiswitch 1/2
15.2. Multiswitch 1/2
15.2. Multiswitch 1/2
15.2. Multiswitch 1/2
Here you can configure up to two multiswitch boards connected via the
aquabus to the aquaero (accessory, not included in delivery). The fol-
lowing settings are available:
Load outputs / LED-outputs:
Here you may determine whether the 8 load- and LED-outputs
should be used as a bargraph and choose the data to be dis-
played. Possible settings:
- No bargraph
- Fan 1-4 rpm
- Fan 1-4 Percent
- Sensor 1-6 Temperature
Switch relay:
Here you can manually switch the relay.
back:
Leaves the submenu.
