AQUAERO
- 34 -
Aqua Computer GmbH & Co. KG
© 2004-2009
Gelliehäuser Str. 1, 37130 Gleichen, Germany
13. Menu "LED Parameters"
13. Menu "LED Parameters"
13. Menu "LED Parameters"
13. Menu "LED Parameters"
Select one of the two LEDs from the list by pressing the buttons "up" and
"down" and confirm your selection by pressing the button "set/mode".
To exit the menu "LED Parameters" select the entry "Back" and confirm
your selection by pressing the button "set/mode".
13.1. Sensor 1 (auto)
13.1. Sensor 1 (auto)
13.1. Sensor 1 (auto)
13.1. Sensor 1 (auto)
Select a temperature sensor after which the brightness of the LED should
be regulated. Selectable sensors are sensors 1 to 6 as well as "All Sen-
sors" and "No Sensor". The brightness of the LED is determined by the
start-up and full load thresholds of the sensors. If more than one sensor
is selected per LED, the sensors are first analyzed individually and the
highest result (i.e. the highest brightness) is used to control the LED.
If the brightness of the LED was manually adjusted, this call deactivates
the manual regulation and activates the temperature-dependent regula-
tion.
13.2. Sensor 2 (auto)
13.2. Sensor 2 (auto)
13.2. Sensor 2 (auto)
13.2. Sensor 2 (auto)
see also 13.1. Sensor 1 (auto).
Allows the selection of an additional sensor to regulate the brightness of
the LED.
13.3. Brighter/Darker
13.3. Brighter/Darker
13.3. Brighter/Darker
13.3. Brighter/Darker
Select here whether the LED should become brighter or darker with in-
creasing temperature at the assigned sensors.
13.4. Brightness
13.4. Brightness
13.4. Brightness
13.4. Brightness
Activate the manual regulation of the brightness for the LED and allows
the setting of a constant brightness. The entered value is represented by
a graphical bar.
If the brightness of the LED was regulated temperature-dependent, this
call deactivates the temperature-dependent regulation and activates the
manual regulation.
