APRILIA TUAREG 660, Service Station Manual

Page: 121 / 311

engine above 8000 rpm (it is not nec-
essary to stay there, it is sufficient to
exceed it);
•
Close the throttle completely and wait
for the engine to go down to idle speed;
•
Repeat this procedure three times.
The success of the procedure is confirmed by the
immediate turning off of the MIL light (in the pres-
ence of other errors the MIL light may remain on
but in any case stops flashing).
Switch off the panel and wait for at least one mi-
nute (Power Latch).
CAUTION
DURING THE ENGINE TONE WHEEL PROGRAMMING
PROCEDURE, THE VEHICLE'S SPEED MUST ALWAYS BE
0 km/h.
IN CERTAIN CASES, EVEN SMALL VIBRATIONS GENER-
ATED BY THE ENGINE (WITH THE ENGINE IN NEUTRAL
POSITION AND THE SIDE STAND EXTENDED/OPEN, THE
INSTRUMENT PANEL DOES NOT DETECT THE VEHICLE'S
SPEED), MAY CAUSE THE PROCEDURE TO FAIL, WHICH
MEANS IT HAS TO BE REPEATED.
IN THIS CASE, REPEAT
THE PROCEDURE WITH THE SIDE STAND CLOSED AND
VEHICLE IN NEUTRAL ALWAYS PAYING EXTREME AT-
TENTION. FOR MORE SAFETY, POSSIBLY BLOCK THE
VEHICLE AGAINST A WALL.
CAUTION
PROGRAMMING OF THE TONE WHEEL TAKES PLACE
DURING THE RELEASE PHASE OF THE THROTTLE
(FROM 8000 rpm TO IDLE RPM). IN THIS DESCENDING
PHASE THE THROTTLE GRIP MUST REMAIN COMPLETE-
LY CLOSED.
TUAREG 660
Electrical system
ELE SYS - 121