Installation and Setup
15
Epica DGX 32 Instruction Manual
Installation and Setup
UL Safety Certifications, Notices, and Recommendations for Laser Products
Per UL requirements, make note of the following:
The DGX SC Optical Boards comply with IEC Standard: IEC 60825-1, 2001.
The boards also comply with 21 CFR 1040.10 and 1040.11 except for deviations pursuant
to Laser Notice No. 50, dated June 24, 2007.
The DGX SC Optical Output (TX) Boards are CLASS 1 LASER PRODUCTS.
The maximum output power of the laser radiation is 4.08 mW.
Since the class of radiation emitted from the fiber port can be Class 3R when the fiber cable or dust plug
is removed, a yellow and black label with the following caution is located on the rear of the enclosure on
the far right.
Important: No user serviceable parts are included inside an AMX AutoPatch product; service should
only be done by qualified personnel.
Caution: Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
Exercise caution when installing DGX products to avoid direct eye exposure to invisible laser radiation.
Follow the recommendations below whenever installing or working with DGX products.
Be sure to apply the power last, so that the fiber connector is not exposed when power is
applied.
Do not remove dust plugs from SC fiber connectors or the dust caps from the fiber cables until
establishing connections; avoid direct eye exposure.
Ensure all cables, including fiber cables, are correctly connected and/or terminated.
If you need to unplug a fiber cable on an input board, disconnect the power on the DGX TX that
is connected to the input.
If you need to unplug a fiber cable on an output board, disconnect the switch for that output
connector.
FIG. 6
Caution label for Class 3R laser products
Summary of Contents for Epica DGX 32
