![background image](http://html1.mh-extra.com/html/amx/epica-dgx-32/epica-dgx-32_instruction-manual_2938448143.webp)
Appendix E – Board Replacement
137
Epica DGX 32 Instruction Manual
Appendix E – Board Replacement
This appendix covers the removal and replacement procedure for an Epica DGX 32 board.
The procedure can be done while the system is powered up.
Procedure Overview
Important: Adding or replacing boards should only be done by personnel trained to handle
ESD sensitive parts and assemblies.
ESD Warning: To avoid ESD (Electrostatic Discharge) damage to sensitive components,
make sure you are properly grounded before touching any internal Epica DGX 32 materials.
Use an ESD wristband and cord with alligator clip attached to a good ground source.
Items Required
Epica DGX 32 Board(s)
Phillips #1 screwdriver
ESD wristband and cord with alligator clip
PC with Terminal Emulation program (e.g., HyperTerminal) and RS-232 null modem cable
Safety Recommendations for Laser Products
Important: No user serviceable parts are included inside an AMX AutoPatch product; service should
only be done by qualified personnel.
Caution: Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
Exercise caution when installing DGX 32 SC Optical Boards to avoid direct eye exposure to invisible
laser radiation. Follow the recommendations below whenever installing or working with DGX products.
Be sure to apply the power last, so that the fiber connector is not exposed when power is
applied.
Do
not
remove dust plugs from SC fiber connectors or the dust caps from the fiber cables until
establishing connections; avoid direct eye exposure.
Ensure all cables, including fiber cables, are correctly connected and/or terminated.
If you need to unplug a fiber cable on an input board, disconnect the power on the DGX TX
that is connected to the input.
If you need to unplug a fiber cable on an output board, disconnect the switch for that output
connector.
Summary of Contents for Epica DGX 32
