![background image](http://html1.mh-extra.com/html/amx/epica-dgx-32/epica-dgx-32_instruction-manual_2938448038.webp)
Installation and Setup
32
Epica DGX 32 Instruction Manual
2.
If the port specifies the Com number, go to Step 4.
If the port does not specify the Com number, right-click AutoPatch USB Bridge and select
Properties and complete all remaining steps.
3.
In the AutoPatch USB Bridge Properties dialog box, select the General tab.
4.
Make note of the Com port assigned to the AutoPatch USB Bridge.
This port number
must
be
entered when setting a connection in a software program or terminal emulation program. The PC
will always associate a specific USB connector with the assigned virtual Com port. The PC will not
recognize the Epica DGX 32 if you disconnect and reconnect using a different Com port on the PC.
However, it will attempt to install a new virtual Com port using the new port. If completed, the new
port will be assigned a different Com number.
5.
Set up and run the desired application:
AMX Controller
– For control programming information, see the instruction manual for the
specific interface.
APControl 3.0
– Install and open the program (located on the AMX AutoPatch CD). Follow
the setup wizard. Manually create the VM (virtual matrix) and specify the number of inputs
and outputs. Open the APControl Launchbar. From the Launchbar menu, select Views /
CrossBar and click the crosspoints to execute switches.
Terminal emulation
– Open the program. Check to be sure
the Communications Port option is set for the port
determined in the previous steps. Set the settings to match
the default ones in the Epica DGX 32 Serial Port Settings
table to the right. Click OK. A short splash screen appears.
XBar (NXB-AP-1000 Interface)
– See page 93.
Assigned port number
(if not displayed, complete
all remaining steps)
Com port number to
enter when setting a
connection in terminal
emulation program
Step 5 -- Set up and run
the desired application:
Epica DGX 32
Serial Port Settings
Baud Rate
9600
Data Bits
8
Parity
None
Stop Bits
1
Flow Control
None
Summary of Contents for Epica DGX 32
