Control Panel Operation
62
Epica DGX 32 Instruction Manual
4.
Press Input Keys 1 and 3 and Output Key 9.
The keys turn white indicating that they are selected.
5.
Press the Take Key.
Inputs 1 and 3 (and all outputs connected to them) and Output 9 are disconnected as soon as the
Take Key is pressed and the keys turn blue.
6.
Make additional disconnects.
Or
press the Function Key to return to the Function menu.
Verifying Signal Status
The status of inputs or outputs can be checked using the Epica DGX 32 Control Panel. Signal status can
be verified to confirm that a switch has executed properly or to confirm correct routing to multiple
outputs (destinations). Verifying an input will illuminate all outputs currently receiving the input’s
signal. An output can only be connected to one input (source); therefore, verifying the status of an output
will illuminate only the one input that is currently routed to it.
Once the Control Panel is in Status Mode, inputs and outputs can be selected by pressing the
corresponding Input and Output Keys without changing the routing state. The panel stays in Status Mode
until the Function Key is pressed.
To verify signal status on a different virtual matrix, see “Changing the Virtual Matrix” on page 60.
To verify the status of a signal:
1.
Press the Function Key.
The Function menu appears.
2.
Locate Status by scrolling with the Control Dial.
3.
Press the Select Key.
The system is in Status Mode (all available Input and Output Keys turn blue).
4.
Press the Input Key that corresponds to the input you want to check.
The selected Input Key turns white, and any Output Keys receiving the input signal also turn white.
Or
press the Output Key that corresponds to the output you want to check.
The selected Output Key turns white, and if an Input Key routed to it, that key also turns white.
5.
Select another signal to verify.
Or
press the Function Key to return to the Function menu.
Virtual matrix
Virtual matrix
Summary of Contents for Epica DGX 32
