Installation and Setup
43
Epica DGX 32 Instruction Manual
To test the NXB-AP-1000 Server connection:
1.
Launch a browser on the PC.
2.
In the address bar of the browser, type the IP address and press Enter (to determine the IP address,
see the instructions for accessing Zero-config information above).
If the NXB-AP-1000 Interface page does not open, see the “NXB-AP-1000 Troubleshooting”
section below.
For NXB-AP-1000 Interface setup details, see the “NXB-AP-1000 Interface – Initial Setup by Network
Admin” chapter on page 77.
Once set up, the NXB-AP-1000 Interface includes the option of using an XBar controller which allows
for remote control of the Epica DGX 32 Matrix Switcher (see page 93).
For additional information on Zero-Config or the WebConsole, see the “NetLinx Integrated Controllers
WebConsole & Programming Guide” at
www.amx.com
.
NXB-AP-1000 Troubleshooting
Check the following:
All power, signal, and link connections on all of the equipment.
LED indicators for the TCP/IP (RJ-45) connector on the rear of the Epica DGX 32.
If the LED indicators are not illuminated, check the cable type to make sure it meets cable
requirements (see page 41).
LED indicators on the NetLinx Master.
Ping the system, i.e., at the DOS prompt enter: ping XXX.XXX.XXX.XXX
(where XXX.XXX.XXX.XXX is the NXB-AP-1000 Interface IP address; page 80).
Try the following:
Try connecting to the NXB-AP-1000 Interface again.
If the NXB-AP-1000 Interface still does not open, you may need to add an exception in the
Proxy Setting dialog box (see page 99).
Tip: Also check “Test Switch Troubleshooting” on page 39 and the troubleshooting information in the
documentation for the NetLinx Master.
If problems persist, contact technical support (see page 40).
Summary of Contents for Epica DGX 32
