Control Panel Operation
60
Epica DGX 32 Instruction Manual
3.
Press Input Key 1.
Input Key 1 flashes indicating that it is ready to switch.
(Any outputs currently connected to Input 1 will turn white.)
4.
Press Output Key 1.
Output Key 1 illuminates indicating that it is ready to accept the switch.
5.
Press the Take Key.
Input 1 switches to Output 1, and the keys turn blue.
The panel remains in Change Mode until the Function Key is pressed.
Changing the Virtual Matrix
The Epica DGX 32 system supports two virtual matrices for switching signals, VM 0 = “All” and
VM 1 = “Video.” The system also supports any custom virtual matrices created in XNConnect; 2 digits
are the maximum allowed (0 through 99). VM 0 is the factory default, and for the Epica DGX 32, VM 0
normally routes the same as VM 1. If you create a custom configuration, you will need to change the
virtual matrix on the control panel to execute switches (or other operations) using the custom virtual
matrix.
Note: When audio is transmitted along with the video over fiber cable, the audio switches on the
same VM as the video (the audio and video cannot be switched independently).
The directions below give the steps to change from routing signals on VM 0 to routing on a custom
configuration (VM 2).
To change the virtual matrix:
1.
Press the Function Key.
The Function menu appears.
2.
Locate Virtual Matrix by scrolling with the Control Dial.
3.
Press the Select Key.
The V.Matrix list appears.
4.
Scroll with the Control Dial to 2:Custom.
5.
Press the Select Key to enter your selection.
The display returns to the top of the V.Matrix
submenu.
VM 2 “Custom” becomes the new virtual matrix used for all operations.
Current virtual matrix
Newly selected virtual matrix
Summary of Contents for Epica DGX 32
