![background image](http://html1.mh-extra.com/html/amx/epica-dgx-32/epica-dgx-32_instruction-manual_2938448067.webp)
Control Panel Operation
61
Epica DGX 32 Instruction Manual
6.
Press the Function Key to return to the Function menu.
The system is ready to execute operations on VM 2. The system will remain on VM 2 for all
operations until the virtual matrix is changed or the power is cycled (at which time the Control
Panel will switch on the default virtual matrix).
Note: To change the default virtual matrix, see the instructions on page 72.
Disconnecting Switches
Disconnecting a switch deactivates the connection between an input (source) and one or more output
(destination) devices. Disconnecting an input will disconnect all outputs currently receiving the input's
signal. An output can only be connected to one input; therefore, disconnecting an output will only
disconnect the connection between the output and the input that is routed to it. Inputs and outputs can be
selected in the same disconnect command.
You can disconnect inputs or outputs from the Epica DGX 32 Control Panel using the steps below. If you
need to change the virtual matrix, see “Changing the Virtual Matrix” on page 60.
Note: When you put the panel in Disconnect Mode, the available keys will be blue and any
unavailable ones will not be illuminated. When you select a blue key, it turns white. You can toggle
the keys between the selected (white) and unselected (blue) state before pressing the Take Key.
An example is provided in FIG. 32 on page 56.
Once the Control Panel is in Disconnect Mode, inputs and outputs can be selected and unselected by
pressing the corresponding Input and Output Keys. The disconnect command is not executed until the
Take Key is pressed. Pressing the Cancel Key clears an incomplete disconnect command and returns the
display to the beginning of the submenu.
While in Disconnect Mode, the Control Panel will not show current routing for the inputs and outputs
that are selected.
Caution: Disconnecting an input disconnects all outputs receiving that source signal even if a
specific output(s) is selected at the same time.
The example on the next page disconnects Inputs 1 and 3 and all outputs connected to them as well as
Output 9.
To disconnect inputs and outputs:
1.
Press the Function Key.
The Function menu appears.
2.
Locate Disconnect by scrolling with the Control Dial.
3.
Press the Select Key.
The system is in Disconnect Mode (all the available Input and Output Keys turn blue).
Summary of Contents for Epica DGX 32
