Ampac SP Series, Installation, Commissioning & Operation

Page: 79 / 112

FireFinder
™
Installation Commissioning & Operation
Page 73
Network: Note : This option is only available if the system configuration is networked.
p
Is pressed to access NETWORK STATUS.
DISPLAY NETWORK STATUS
0: NETWORK POINTS 1: REMOVE SLAVE MODULES
2: REMOTE EXTERNAL MIMIC MODULES
SELECT NO.
Figure 89: Display Network Status
m
Network Points:
DISPLAY NETWORK POINTS
0: STATUS 1: POWER SUPPLY 2: BRIGADE
SELECT NO.
Figure 90: Display Network Points
Network Points Screens are
Press or or
m
Status
n
Power Supply
o
Brigade
LCD LCD LCD
Displays
Select network point
Displays
Charger volts
Displays
Operational
Eg. Loop number Battery Detected Non- Op
Mains OK
n
Remote Slave Modules:
Select from Network Status Remote Slave Modules, then Module number, then ENTER .
Apollo Loop No: 1
TYPE: APOLLO LOOP NO: 1 VER: 6.2
NP: 1 MOD: 1 STAT: NORMAL
REMOTE MODULE STATUS
Figure 91: Display Remote Module Status
o
Remote External LED Mimic Modules:
Select from Network Status Remote External LED Mimic Modules, then NP number, then ENTER, then
External LED Mimic number, then ENTER
q
Is pressed to access SYSTEM STATUS.( If the system configuration is not networked Press
p
)
SYSTEM STATUS
ALARMS: 0000 PREALARMS: 0000 ISOLATES: 0000
SENSOR FAULTS: 0000 MOD FAULTS: 0000 WDOG: 00
LOOP FAULTS: 00 VERSION: 6.0.30/AS4428
Figure 92: System Status