3-10
Operator's Manual
Note
The Auto Pan must be programmed for Pattern 1 only.
6.
Press the number 1 on the keypad.
The following message appears on the LCD:
RECORD PATTERN 45
FINISH W <NEXT>
7.
The Auto Pan is now being recorded. Any extraneous up or down
movement will be ignored when programming the Auto Pan.
8.
Move the camera until you see end point for the Auto Pan you are
programming. Keep in mind this end point must be less than one full
revolution of the dome.
9.
When you see the end point, press the
Next
button.
The following message appears on the LCD:
CAM 8 PATTERN
MON 2 SAVED
The T
OUCH
T
RACKER
automatically returns to the camera control mode.
Record each Auto Pan you define on a copy of the Dome Configuration
Worksheet included in Appendix A. This worksheet provides a space for
describing the Quick View, Patterns, and Dome Inputs and Outputs
configured for your system.
To test the programming of the Auto Pan, press 1, then
Pattern.
The Auto
Pan will run continuously until a camera command, such as tilt or zoom, is
issued.
