2-8
Operator's Manual
3.
Use the number buttons to enter the number of the Quick View you want
to display, and then press the
View
button.
If the Quick View exists for that camera, the camera will immediately
point to the pre-defined Quick View, and then zoom and focus
automatically. The following information appears on the LCD:
CAM 12
MON 3 VIEW 4
If you tried to call up a Quick View for a non-programmable dome, or if
you entered an invalid View number (any number greater than 96), the
T
OUCH
T
RACKER
beeps.
Running Patterns
A
Pattern
is a sequential series of pan, tilt, zoom, and focus movements from
a programmable camera. You “teach” the camera a combination of these
movements. Then when you run the Pattern, the camera automatically repeats
the movements you taught it.
You can define your own Patterns to support your specific needs. Refer to
Chapter 3, “Defining Automatic System Functions,” for procedures on
defining Patterns.
When you run a Pattern, you can specify that you want the Pattern to run
once, or you can specify that you want the Pattern to repeat itself until you
stop it manually. Both methods are described here.
The Dome Configuration Worksheet in Appendix A allows to list which
Patterns are available for which domes. Make copies of this worksheet for
each dome installed at your facility.
The following procedure describes how to run a Pattern. Each programmable
dome can have up to three Patterns defined for it.
1.
Use the number buttons to enter the number of the monitor where you
want the video displayed. Then press the
Monitor
button.
