Amada UNIFLOW 4 REMOTE, Operation Manual, Page: 93 / 176

CHAPTER 4: OPERATING INSTRUCTIONS
UNIFLOW
®
4 PULSED HEAT CONTROL
990-908 4-11
Section V: Operating Instructions
When the
SYSTEM READY
message displays after Power Up, the Control is ready for operation using
either of the following options:

Pre-Defined Reflow Profiles. For your convenience, you may quickly select a profile stored in
the Control that has been pre-defined for your most common reflow applications.

Direct Input. You may use the front panel controls to input the parameters for a reflow
application.
Pre-Defined Reflow Profiles
1. Push the
PROFILE NUMBER
up/down keys until the profile you
want (
1

63
) is displayed on the LCD screen.
NOTE:
The PROFILE NUMBER
up/down keys are disabled
when any screen other than the graphic screen or data screen
displays on the LCD.
2. Set the
HEAT/NO HEAT
switch to
HEAT
. The Control is now
ready to use.
Direct Input
CAUTION
You can accidentally overwrite (erase) an existing stored profile when using the front
panel controls. Before you start
Direct Input , use the
PROFILE NUMBER
up/down
keys to select a profile number that is “blank” or “expendable” to prevent overwriting
a profile you want to keep.
1. Set the
HEAT/NO HEAT
switch to
HEAT
. In this position, the
Control will deliver heating energy to the thermode when you
initiate the heating cycle.