Amada UNIFLOW 4 REMOTE, Operation Manual, Page: 84 / 176

CHAPTER 4: OPERATING INSTRUCTIONS
UNIFLOW
®
4 PULSED HEAT CONTROL
4-2 990-908
Section II: Power Up
Powering Up
To turn the Control power ON, set the
circuit breaker/power switch on the rear
panel to the ON position. After one
introductory screen is displayed, the
GRAPH screen will display with the
SYSTEM READY
message.
NOTES:

If the EMO jumper plug is not
installed as described in
Chapter 2, Installation and
Setup
, the LCD Screen will
display a message saying that
an emergency stop is in effect.
The Control will
not operate until the jumper is installed.

If the Control has been setup with the Idle temperature on, the message
WARM UP IN
PROGRESS – PLEASE WAIT
will be displayed while the Control heats to the set Idle
Temperature. Once the Idle Temperature is reached, the
SYSTEM READY
message will be
displayed.