Amada UNIFLOW 4 REMOTE, Operation Manual, Page: 149 / 176

APPENDIX D: COMMUNICATION CODES
UNIFLOW
®
4 PULSED HEAT CONTROL
990-908 D-11
ALARM=03
OUTOFLIMIT=04
CLEANTHERM=05
REPLACETHERM=06
IDLEHEAT=07
BASEHEAT=08
RISE1=09
PREHEAT=10
RISE2=11
REFLOW=12
COOL1=13
ENDOFREFLOW=14
CYCLEPWR=15
NOTACTIVE_TRIG = 16
, 1 Byte
Relays2.on_off (As above) 1 Byte
, 1 Byte
Relays2.when (As above) 2 Byte
, 1 Byte
Relays3.on_off (As above) 1 Byte
, 1 Byte
Relays3.when (As above) 2 Byte
, 1 Byte
Relays4.on_off (As above) 1 Byte
, 1 Byte
Relays4.when (As above) 2 Byte
, 1 Byte
Relays5.on_off (As above) 1 Byte
, 1 Byte
Relays5.when (As above) 2 Byte
, 1 Byte
Relays6.on_off (As above) 1 Byte
, 1 Byte
Relays6.when (As above) 2 Byte
, 1 Byte
Relays7.on_off (As above) 1 Byte
, 1 Byte
Relays7.when (As above) 2 Byte
34 Bytes Total
RESET
“RX” Reset Resets system 0 Bytes
SECURITY
“SR” Read Read Security Locks 0 Bytes
“SS” Set Password (0000000 – 9999999) 7 Bytes
(Note: Password is not set by this command. It must match the password in the unit in order to set security locks below)
, 1 Byte
ProfileLock (Profile Lock: 0 = OFF, 1 = ON) 1 Byte
, 1 Byte
SystemLock (System Lock: 0 = OFF, 1 = ON) 1 Byte
, 1 Byte
ProfileTuneLock (Profile Tuning Lock: 0 = OFF, 1 = ON) 1 Byte