Alvarion BreezeACCESS SU-A-EZ, Product Manual

Page: 98 / 165

Chapter 5 - Command Line Interface LED Operation Mode Commands
BreezeACCESS SU-A-EZ 81 Product Manual
5.4 LED Operation Mode Commands
The following commands configure the SNR LEDs’ behavior.
5.4.1 set ClientSta ledMode
Sets the SNR LEDs behavior
Syntax
set ClientSta ledMode < normal | threshold >
• normal - LEDs indicate the SNR level
• threshold - Each LED indicates whether a specific threshold is reached. If all the
thresholds that were set up are reached, the entire SNR bar will light up, irrespective of
the number of thresholds that were set.
Default Setting
normal
Command Mode
Installer, Admin
Example
5.4.2 set ClientSta led1Type ~ led7Type
When the SNR LEDs are in threshold mode, this command sets the type of
parameter that is monitored for the respective LED and that the threshold is set
for.
Table 5-2: LED Operation Mode Commands
Command Function Mode Page
set ClientSta
ledMode Sets the SNR LEDs into the Normal or Threshold mode. Installer;
Admin
81
set ClientSta
led1Type ~
led7Type In Threshold mode, this option sets the threshold parameter that is
monitored for the respective LED. Installer;
Admin
81
set ClientSta
led1Mode ~
led7Mode In Threshold mode, this option sets the relational operator that is
applied to the threshold target to determine whether the LED will
light up. Installer;
Admin
82
set ClientSta
led1Target ~
led7Target In Threshold mode, this option sets the threshold target that is
monitored for the respective LED. Installer;
Admin
83
Installer# set ClientSta ledMode threshold
Installer#