Alvarion BreezeACCESS SU-A-EZ, Product Manual, Page: 99 / 165

Chapter 5 - Command Line Interface LED Operation Mode Commands
BreezeACCESS SU-A-EZ 82 Product Manual
Syntax
set ClientSta led#Type < disabled | rssi | crc | snr | modulation >
• disabled - The LED is disabled
• rssi - The LED is monitoring the Received Signal Strength Indicator level.
• crc - The LED is monitoring the Cyclic Redundancy Check percentage.
• snr - The LED is monitoring the Signal-to-Noise Ratio.
• modulation - The LED is monitoring the average modulation level.
Default Setting
disabled
Command Mode
Installer, Admin
Example 1:
Example 2:
5.4.3 set ClientSta led1Mode ~ led7Mode
When the SNR LEDs are in threshold mode, this command sets how the threshold
parameter relates to the threshold target value for the LED that the threshold is
set for.
Syntax
set ClientSta led#Mode < eq | ge | le >
• le - The threshold parameter must be lower than or equal to the threshold target value
for the LED to light up.
• ge - The threshold parameter must be greater than or equal to the threshold target value
for the LED to light up.
• eq - The threshold parameter must be equal to the threshold target value for the LED
to light up.
Default Setting
le
Command Mode
Installer, Admin
Example 1:
Installer# set ClientSta led2Type rssi
Installer#
Installer# set ClientSta led5Type modulation
Installer#
Installer# set ClientSta led2Mode ge
Installer#