Alvarion BreezeACCESS SU-A-EZ, Product Manual

Page: 122 / 165

Chapter 5 - Command Line Interface Ethernet Interface Commands
BreezeACCESS SU-A-EZ 105 Product Manual
5.9 Ethernet Interface Commands
The commands described in this section configure connection parameters used
for unit management.
5.9.1 set ClientSta bridge-mip
This command sets the subnet mask for the interface.
Syntax
set ClientSta bridge-mip < subnet mask >
• subnet mask - The mask that identifies the host address bits used for routing to specific
subnets. Specified as four decimal numbers, 0 to 255, separated by periods
Default Setting
255.0.0.0
Command Mode
Installer, Admin
Example
5.9.2 set ClientSta bridge-static-ip
This command sets the IP address for the interface.
Syntax
set ClientSta bridge-static-ip < IP address >
• IP address - The IP address of the unit. Specified as four decimal numbers, 0 to 255,
separated by periods
Table 5-7: Ethernet Interface Commands
Command Function Mode Page
set ClientSta
bridge-mip Sets the subnet mask for the unit. Installer,
Admin
105
set ClientSta
bridge-static-ip Sets the IP address for the unit. Installer,
Admin
105
set ClientSta
default-gw Sets the default gateway for passing traffic to the unit. Installer,
Admin
106
set ClientSta
dhcpc Enables/disables DHCP on the unit. Instaler,
Admin
106
Installer# set ClientSta bridge-mip 255.255.255.0
Installer#