Alvarion BreezeACCESS SU-A-EZ, Product Manual

Page: 125 / 165

Chapter 5 - Command Line Interface Wireless Commands
BreezeACCESS SU-A-EZ 108 Product Manual
5.10 Wireless Commands
The commands described in this section configure connection parameters for the
wireless interfaces.
Table 5-8: Wireless Commands
Command Function Mode Page
set ClientSta
authentication Defines the 802.11 authentication type allowed by the SU. Installer,
Admin
109
set ClientSta
security-mode Switches between WEP and AES-CCM Installer,
Admin
109
set ClientSta
data-encryption-op
tion Enables/disables data encryption. Installer,
Admin
110
set ClientSta
default-key Sets the key number for transmission. Installer,
Admin
110
set ClientSta
distance Sets the estimated distance between the farthest SU in the cell and
the serving AU. Installer,
Admin
111
set ClientSta
key-1~4 Allows the user to set up to 4 152-bit hexadecimal keys. Installer,
Admin
111
set ClientSta
linkrate Sets the maximum data rate for transmission of wireless packets. Installer,
Admin
112
set ClientSta
mangVLAN Sets the management VLAN ID. Installer,
Admin
112
set ClientSta
modulation Sets a fixed or dynamic data transmission rate. Installer,
Admin
113
set ClientSta
rtsthreshold Sets the packet size threshold at which an RTS must be sent to the
receiving station prior to the sending station starting
communications. Installer,
Admin
113
set ClientSta
txpowerlevel Adjusts the power of the radio signals from the SU. Installer,
Admin
114
set ClientSta
wireless-essid Allows the user to specify an ESSID for the SU. Installer,
Admin
115
set ClientSta
HardwareRetries Sets the maximum number of times that an unacknowledged frame
is retransmitted in each Hardware Retrial pahse Installer,
Admin
115
set ClientSta
PreferredAuMacA
ddress Sets the preferred AU Installer,
Admin
115
set ClientSta
bandwidth Sets the channel bandwidth(s) enabled for the unit Installer,
Admin
116