Alvarion BreezeACCESS SU-A-EZ, Product Manual

Page: 153 / 165

Chapter 5 - Command Line Interface Traffic Prioritization Commands
BreezeACCESS SU-A-EZ 136 Product Manual
5.15.8 set ClientSta UdpPortRanges
This command defines the UDP port ranges used for prioritization. If a frame’s
destination UDP port matches this setting, it will be routed via the High Priority
queue. Otherwise, it will be routed through the Low Priority queue.
Syntax
set ClientSta UdpPortRanges < port ranges >
port ranges - A list of up to 64 UDP priority port numbers or port ranges. Entries are
separated by commas. In ranges, a hyphen is used to separate the start port number
from the end port number. Setting an empty port range string will remove all currently
enabled ranges.
Default Setting
empty
Command Mode
Installer, Admin
Example
5.15.9 set ClientSta TcpPortRanges
This command defines the TCP port ranges used for prioritization. If a frame’s
destination TCP port matches this setting, it will be routed via the High Priority
queue. Otherwise, it will be routed through the Low Priority queue.
Syntax
set ClientSta TcpPortRanges < port ranges >
port ranges - A list of up to 64 TCP priority port numbers or port ranges. Entries are
separated by commas. In ranges, a hyphen is used to separate the start port number
from the end port number. Setting an empty port range string will remove all currently
enabled ranges.
Default Setting
empty
Command Mode
Installer, Admin
Example
Installer# set ClientSta TcpPortPriRtpRtcp RTP
Installer#
Installer# set ClientSta UdpPortRanges 8900,9000-9005,9010,9016-9017
Installer#
Installer# set ClientSta TcpPortRanges 8900,9000-9005,9010,9016-9017
Installer#