Alvarion BreezeACCESS SU-A-EZ, Product Manual, Page: 44 / 165

Chapter 2 - Hardware Installation Connecting the Power Injector IDU Cables
BreezeACCESS SU-A-EZ 27 Product Manual
2.7 Connecting the Power Injector IDU
Cables
The unit can be placed on a desktop or a shelf. Alternatively, it may be
wall-mounted using the kit supplied with the unit.
1
Connect the Ethernet cable from the SU-A-EZ ODU to the RJ-45 port labeled
“Radio” on the power injector IDU.
2
Connect a straight-through unshielded twisted-pair (UTP) cable from a local
LAN switch/router to the RJ-45 port labeled “Ethernet” on the power injector.
If you connect to a workstation, use a crossover cable. Use Category 5E or
better UTP cable for 10/100BASE-TX connections.
CAUTION
Do not install the power injector outdoors. The unit is for indoor installation only.
CAUTION
Install lightning protection at the power injector end of the Ethernet cable, use a lightning arrestor
immediately before the cable enters the building.
NOTE
The SU-A-EZ’s Ethernet port does not support Power over Ethernet (PoE) based on the IEEE
802.3af standard. Do not try to power the unit by connecting it directly to a network switch that
provides IEEE 802.3af PoE. Always connect the unit to the included power injector module.
To connect the IDU cables:
NOTE
The RJ-45 port on the power injector is an MDI port. If connecting directly to a computer, use a
crossover cable