Alvarion BreezeACCESS SU-A-EZ, Product Manual

Page: 149 / 165

Chapter 5 - Command Line Interface Traffic Prioritization Commands
BreezeACCESS SU-A-EZ 132 Product Manual
5.15 Traffic Prioritization Commands
These commands configure the traffic prioritization options for the SU. Frames
can be routed via the High Priority queue or the Low Priority queue based on
various classifiers: VLAN priority, ToS priority, UDP/TCP port ranges or IP
address. When multiple classifiers are enabled, the frame will be routed through
the High priority queue if it meets the conditions set by at least one classifier.
5.15.1 set ClientSta VlanPriorityThreshold
This command sets a threshold for the VLAN priority tag above which frames are
routed via the High Priority queue. Frames with VLAN priority tags lower than or
Table 5-13: Traffic Prioritization Commands
Command Function Mode Page
set ClientSta
VlanPriorityThreshold Sets frame prioritization based on the VLAN priority
tag inside the frame Installer,
Admin
132
set ClientSta
ToSPrioritizationOption Sets the type of ToS prioritization applied Installer,
Admin
133
set ClientSta
IPToSPrecedenceThreshold Sets the threshold value used when the IP
precedence mechanim is enabled Installer,
Admin
133
set ClientSta DSCPThreshold Sets the threshold value used when the DSCP
precedence mechanim is enabled Installer,
Admin
134
set ClientSta
UdpTcpPortRangesPrioOpt Sets the UDP/TCP implementation of the destination
port range based prioritization Installer,
Admin
134
set ClientSta UdpPortPriRtpRtcp Sets the RTP/RTCP implementation of the UDP
destination port range based prioritization Installer,
Admin
135
set ClientSta TcpPortPriRtpRtcp Sets the RTP/RTCP implementation of the TCP
destination port range based prioritization Installer,
Admin
135
set ClientSta UdpPortRanges Sets the destination UDP port ranges used for traffic
prioritization Installer,
Admin
136
set ClientSta TcpPortRanges Sets the destination TCP port ranges used for traffic
prioritization Installer,
Admin
136
set ClientSta IpRangeOption Sets source/destination IP address range traffic
prioritization Installer,
Admin
137
set ClientSta IpRangeIpAddress Sets the base IP address for the IP range used for
traffic prioritization Installer,
Admin
137
set ClientSta IpRangeMask Sets the subnet mask for the IP range used for traffic
prioritization Installer,
Admin
137