Altusen KN1000, User Manual

Page: 80 / 194

KN1000 User Manual
66
Customization
The Customization page allows the Administrator to set Timeout , Login
failure , and Working mode parameters.
An explanation of the Customization parameters is given in the table below:
Parameter Explanation
Timeout If there is no user input for the amount of time specified
here, the user is automatically logged out, and must log in
again before the KN1000 can be accessed. The default is
3 minutes.
Working
Mode Enable
ICMP If ICMP is enabled , the KN1000 can be pinged. If it is not
enabled, the device cannot be pinged. The default is
Enabled.
Enable
device list If this item is enabled , the device will show up in the list of
local KN1000 units on the AP Client Connection screen
(see
The Windows Client Connection Screen , page 133).
If it is not enabled, it will not show up. The default is
Enabled,
Enable
multiuser Enabling Multiuser operation permits more than one user
to log into the KN1000 at the same time. The default is
Enabled,
Force All to
Grayscale If Force All to Grayscale is enabled, the remote display for
all users is changed to grayscale. This can speed up I/O
transfer in low bandwidth situations. The default is
Disabled,