Altigen MAX Communication Server ACM 6.0, Administration Manual

Page: 322 / 448

Chapter 24: Network Configuration Guidelines for VoIP
310
MAXCS ACM 6.0 Administration Manual
Figure 1. MAXCS behind NAT
Figure 1 shows a private network, 192.168.1.0, where MAXCS is installed and running
on a host with a private IP address 192.168.1.2.
Router 1 is a NAT router. The local IP phones—IP Phone 1 and IP Phone 2—use the
private IP addresses 192.168.1.100 and 192.168.1.101, respectively. There are two
remote IP phones: IP Phone 3 with a private IP address 192.168.2.100 connects to the
Internet via Router 2. Router 2 can also sit behind a DSL/Cable Modem.
Setup
For the Corporate LAN:
•
MAXCS
MAXCS is installed (private IP address 192.168.1.2). The public IP address of Router
2 should be configured as the IP address of this IP extension in MAXCS. If it is
changed dynamically, then assign a dynamic IP address configuration for that
extension.
•
Router 1
Router 1 is a NAT router. You need to set up the H323/SIP port forwarding for this
NAT router from 169.254.56.169 to the private IP address of MAXCS 192.168.1.2.
For the Remote IP Phone Using NAT
•
IP Phone 3
When configuring remote IP Phone 3, you should set up the MAXCS IP address to
Router 1’s public IP address — 169.254.56.169.
•
Router 2