Allen-Bradley SLC 500 DeviceNet, User Manual, Page: 87 / 139

1 Publication 1747-6.5.5 - August 2000
Chapter
6
Creating and Running the Example
Application Program
What This Chapter Contains This chapter describes the procedure to create, download, and run an
example ladder logic program to test the DeviceNet network. When
the processor is put into Run mode, pressing the START button on the
network’s RediSTATION will cause the red indicator light to come on
and stay on until the STOP button is pressed. Passing an object in
front of the photoeye will increment a counter.
Recall that you cannot directly communicate with the SLC 500
processor over the DeviceNet network. This chapter shows how to
download and run the program over a ControlNet, Ethernet, or Data
Highway Plus network.
The SLC 500 I/O chassis used for these examples was set up with the
following hardware:
The following table describes what this chapter contains and where to
find specific information.
Module Slot DH+
Address
Ethernet
Address ControlNet
Address
DeviceNet
Address
SLC 500 5/04
(1)
Processor
(1)
Used for Data Highway Plus and ControlNet examples.
0 1 - - -
SLC 500 5/05
(2)
Processor
(2)
Used for Ethernet example.
0 - 130.130.130.2 - -
1747-KFC15 1 - - 16 -
1747-SDN 2 - - - 0
For information about See page
Installing the Software 6-2
Creating the Example Application Program 6-2
Downloading and Running the Program 6-4
Downloading and Running the Program via a ControlNet Network 6-4
Downloading and Running the Program via an Ethernet Network 6-6
Downloading and Running the Program via a DH+ Network 6-8