Allen-Bradley SLC 500 DeviceNet, User Manual, Page: 40 / 139

Publication 1747-6.5.5 - August 2000
3-4 Hardware Setup
Connect channel 1 of the Ethernet SLC 5/05 processor to an Ethernet
hub using 10 Base-T cable as shown below.
See Chapter 5 and Appendix E for information on configuring the SLC
5/05 processor’s Ethernet communications.
Configuring the RS-232 Port for the ControlNet Interface
If you need to communicate with your SLC 500 via a ControlNet
network you must install a 1747-KFC15 ControlNet Interface module
in the chassis with your processor. You can use either a 5/04 or a 5/05
processor. The 1747-KFC15 module connects to the SLC 500 via the
processor’s RS-232 port (channel 0).
TIP
You can use your RSLogix 500 programming
software to set the SLC 5/04 processor’s RS-232
channel configuration. See Appendix C.
Ethernet
Hub
RJ45 connectors on both
ends of cable (10Base-T)
to Host Platform
Ethernet card
to SLC 5/05
Channel 1
More