Allen-Bradley SLC 500 DeviceNet, User Manual, Page: 42 / 139

Publication 1747-6.5.5 - August 2000
3-6 Hardware Setup
For this configuration, set the switches as shown in the tables below.
Refer to the SLC 500 ControlNet RS-232 Interface User Manual,
publication 1747-5.34, for information on setting and verifying the
1747-KFC15 and SLC 500 processor communication parameters
.
Bank S1 DIP Switches
Switches 1-3
Upper digit of
DF1 station
address SW 1 SW 2 SW 3 Digit
ON ON ON 0
Switches 4-6
Lower digit of
DF1 station
address SW 4 SW 5 SW 6 Digit
ON ON ON 0
Switches 7-8 both OFF
Bank S2 DIP Switches
Switches 1-3
Serial Port
Baud Rate SW 1 SW 2 SW 3 Baud Rate
ON OFF OFF 19200
Switch 4 Full/Half Duplex OFF = Full Duplex
Switch 5 Parity OFF = No Parity
Switch 6 Odd/Even Parity not applicable
Switch 7 Handshake OFF = Hardware handshake disabled
Switch 8
Diagnostic
Command
Execution OFF = Disabled
Bank S3 DIP Switches
Switch 1 Duplicate Detect ON = Duplicate detect on
Switch 2 Error Detect OFF = CRC error check
Switches 3-4
Number of
Retries SW 3 SW 4 Number of retries
ON ON 0
Switches 5-8
DF1 ACK
Time-out
SW 5 SW 6 SW 7 SW 8 Time
Out
OFF OFF OFF OFF 3.2
More