Allen-Bradley SLC 500 DeviceNet, User Manual, Page: 43 / 139

Publication 1747-6.5.5 - August 2000
Hardware Setup 3-7
Configuring the 1747-KFC15 Module’s ControlNet Node Address
The 1747-KFC15’s ControlNet node address is set by rotary switches
S4 and S5 on the top of the module. Switch S5 sets the upper digit of
the address and S4 the lower. These switches can be turned by hand
while holding the module in the orientation illustrated below.
We set the ControlNet node address to 16 for the example application.
Refer to Chapter 5 and Appendix B for more information on
configuring ControlNet communications for the example application.
Installing the 1747-KFC15 Module in the Chassis
1. Remove power from your 1746 I/O chassis.
2. Install the 1747-KFC15 module into an empty I/O slot. The
1747-KFC15 module must be placed near enough to the SLC
processor to connect the supplied RS-232 cable between them. We
used slot 1 for the example application.
ATTENTION
!
Electrostatic discharge can damage semiconductor
devices inside the KFC15 module. To guard against
electrostatic damage wear an approved wrist strap
grounding device, or touch a grounded object to rid
yourself of electrostatic charge before handling the
products.
Front of
Module
Back of
Module
S4
S5
ControlNet node address = 16
30
40
50
60
70 80
90
00
10
20 3
4
5
6
7 8
9
0
1
2 30
40
50
60
70 80
90
00
10
20
More