Allen-Bradley SLC 500 DeviceNet, User Manual, Page: 92 / 139

Publication 1747-6.5.5 - August 2000
6-6 Creating and Running the Example Application Program
Downloading and Running the Program via an Ethernet Network
Follow the procedure below to download and run the example
program via an Ethernet network.
1. Click on the RSLogix 500 Communications menu and select
System Comms .
2. The Communications window will open (Your window may look
different depending upon the drivers you have installed):
3. Select the “+” next to your Ethernet driver ( AB-ETH-1 above) to
expand the tree.
4. Highlight the SLC 500 processor as shown above and click on the
Download button.
5. After the download is complete, change the SLC 500 processor
mode to
Run .
IMPORTANT
To communicate with your SLC 5/05 processor over
an Ethernet network you must first configure the
processor’s Ethernet communications channel and
assign it a unique IP address. See Appendix B for
information on configuring the Ethernet
communications channel.